济南模型公司
  • 济南市市中区
  • 经十西路6288号1号楼101室
  • 电话:0531-55504101
  • 网站:http://www.jnsymx.com
  • 手机:18660800958 13869134430
新闻中心当前位置:首页-新闻中心
    怎样用自喷漆给建筑模型上色?
    2019-2-3 19:38:22 来源:http://www.jnsymx.com
    色是建筑模型制作中非常重要的一道工序。目前,市场是出售的涂料品种很多,有调和漆,自喷漆,磁漆等。在这些涂料中,应首选自喷漆涂料,因为这种色剂覆盖力强,操作简便,干燥速度快,而且色彩感觉好。下面,来给大家说说自喷漆给建筑模型的操作步骤,希望对建筑模型制作爱好者有所帮助。
    Color is a very important process in building model making. At present, there are many kinds of coatings on sale in the market, such as blending paint, self-spraying paint, enamel paint, etc. Among these coatings, self-spraying paint should be preferred because of its strong coverage, easy operation, fast drying speed and good color feeling. Next, let's talk about the operation steps of self-spraying paint for building models. I hope it will be helpful for building model making enthusiasts.
    怎样用自喷漆给建筑模型上色?
    How to colour the building model with self-spray paint?
    自喷漆上色首先将被喷物体用酒精擦拭感觉,并选择好颜色合适的自喷漆,然后将自喷漆罐上下摇动约20s,待罐内漆混合均匀后即可使用。喷漆时,要注意被喷物和喷漆罐的角度和距离。一般被喷物与喷漆罐的夹角在30-50度之间,喷色距离在300mm左右为宜。具体操作时应采取少量多次喷漆的原则,每次喷漆间隔时间一般在2-4min.雨季或气温较低时,应适当地延长间隔时间。在进行大面积喷漆时,每次喷漆的顺序应交叉进行,即遍由上至下,第二遍由左至右,第三遍再由上至下依次转换,直至达到理想的效果。
    The self-spraying paint first wipes the sprayed object with alcohol and chooses the suitable self-spraying paint. Then the self-spraying paint can be shaken up and down for about 20 seconds, and can be used when the inner paint of the can is mixed evenly. When spraying paint, attention should be paid to the angle and distance between the object being sprayed and the spraying pot. Generally, the angle between the sprayed object and the paint can is between 30 and 50 degrees, and the spray distance is about 300 mm. The principle of a small amount of multiple spraying should be adopted in the specific operation. The interval time of each spraying is usually 2-4 minutes. When the rainy season or the temperature is low, the interval time should be prolonged appropriately. In large area spraying, the order of each spraying should be crossed, that is, the first time from top to bottom, the second time from left to right, and the third time from top to bottom in turn, until the desired effect is achieved.
    在喷漆的实际操作中,如果需要有光泽的表层效果时,在喷漆过程中应缩短喷漆距离并均匀地减缓喷漆速度,从而使被喷物表层在干燥后就能形成平整而光泽的漆面。但应该指出的是,在喷漆时,被喷面一定要水平放置,以防漆层过厚而出现流挂现象。如果我们需要亚光效果时,在喷漆过程中要加大喷漆距离和加快喷漆速度,使喷漆在空中形成雾状并均匀地散落在被喷面表层,这样重复数遍后漆面便形成颗粒状且无光泽的表层效果。
    In the actual operation of spraying paint, if there is a need for a glossy surface effect, the spraying distance should be shortened and the spraying speed should be slowed down uniformly during the spraying process, so that the surface of the sprayed object can form a smooth and glossy surface after drying. However, it should be pointed out that when spraying paint, the sprayed surface must be placed horizontally in order to prevent the phenomenon of hanging when the paint layer is too thick. If we need matte effect, we should increase the distance and speed of spraying in the process of spraying, so that spraying sprays form fog in the air and evenly scatter on the surface of the sprayed surface, so that after repeated several times, the surface of the paint will form a granular and glossy surface effect.
    自喷漆是一种较为理想的上色剂,但是由于目前市场上出售的颜色品种有限,从而给自喷漆的使用带来了局限性,如果在进行上色时在自喷漆中选择不到合适的颜色,便可使用磁漆或调和漆来替代。
    Self-spraying paint is an ideal colouring agent, but because of the limited variety of colours sold on the market at present, the use of self-spraying paint has brought limitations. If the suitable colour can not be selected in self-spraying paint, it can be replaced by enamel or blending paint
    版权所有:济南市槐荫区视野模型设计制作中心 Copyright @ 2011-2012 电话:18660800958  传真:0531-55504101 鲁ICP备11014722号 地址:济南市市中区经十西路6288号1号楼101室 
    网址:http://www.jnsymx.com